What i60 means on your Frigidaire dishwasher (frigidaire i60 error)
A frigidaire i60 error means the water did not reach its target temperature in time on your Frigidaire dishwasher. The control monitors heat during the main wash, and when it stalls, wash and dry performance both suffer. It usually indicates a heating element or sensor problem.
Symptoms
Checking these signs against your Frigidaire dishwasher keeps you from chasing the wrong fault, because look-alike problems call for quite different repairs. A dishwasher can show a single symptom or several combined, creeping in gradually or appearing suddenly after a surge, a spill, or fresh install work.
- Poor wash or dry results
- A long heat-delay pause in the cycle
- Dishes are cool and filmy at the end
- The cycle runs much longer than normal
Common causes
These symptoms on a Frigidaire dishwasher can spring from several different faults, so look at the likeliest first before anything exotic. That order makes it clear whether your dishwasher needs no more than a check or a proper repair with correct Frigidaire parts.
- Failed heating element — the element no longer heats the water
- Faulty thermistor — the temperature sensor misreads
- Cold incoming water — supply water is below the usable minimum
- Control-board fault — the heat circuit output has failed (technician)
Troubleshooting steps you can try
Run these steps on your Frigidaire dishwasher in the sequence shown before you pick up the phone. If the next move on the dishwasher would put you near mains wiring, gas, a hot cavity, water, or a sealed system, stop and let a qualified technician take over from there.
- Confirm the household water heater is delivering hot water and run a hot tap before starting.
- Power-cycle the dishwasher and restart a heated cycle.
- Note whether the unit pauses indefinitely, which is the HO heat-delay status rather than i60.
- If i60 persists, the element and thermistor need testing.
Parts a technician may replace
Depending on where the fault is traced, work on your Frigidaire dishwasher may involve inspecting, testing, or replacing the heating element, thermistor, high-limit thermostat, and control board. Each component for the dishwasher is matched from the model and serial number, and genuine OEM parts are sourced from trusted suppliers rather than generic substitutes, so the performance, safety, and long working life of the appliance are safeguarded. Confirming the failed part before it is ordered keeps the repair on your dishwasher to the fault at hand.
When to call a technician
i60 generally needs a technician to test the heating element and thermistor. The condition sits at Medium severity, which is not an emergency for a dishwasher; all the same, if i60 comes back after the checks, have a technician confirm the cause on your dishwasher before any part is replaced. This is independent repair work — we are not affiliated with the manufacturer, the technicians who service your dishwasher are experienced and skilled, the parts fitted to the dishwasher are genuine OEM items from trusted parts suppliers, and a 30-day labor warranty covers our workmanship. Have the model and serial number of your Frigidaire dishwasher ready when you book so the right part is matched before the visit and the i60 condition cleared in as few trips as possible.
Related help and Frigidaire resources
If the i60 condition keeps returning after these checks, book Frigidaire dishwasher repair, browse our dishwasher error-code guides and step-by-step repair guides, or schedule service in your area on our locations page. See also the related HO heat-delay status. Full manufacturer specifications for your Frigidaire dishwasher, plus the model lookup, are published at frigidaire.com.
