What PF means on your Frigidaire dishwasher (frigidaire pf error)
A frigidaire pf error means power was lost mid-cycle on your Frigidaire dishwasher, or the supply voltage dropped too low. PF is informational: it tells you the cycle was interrupted so you can restart it. Frequent PF without outages points at a wiring problem.
Symptoms
Read the list through and set it beside how your Frigidaire dishwasher is behaving, because faults with very different fixes can look alike at first glance. The dishwasher may reveal a single symptom or a group of them, appearing gradually or the instant after a power blip, a heavy load, or new installation work.
- The code appears after an outage or breaker trip
- The cycle stopped partway through
- The display reset
- PF clears when you restart the cycle
Common causes
It takes only one of the faults below to make a Frigidaire dishwasher act like this, but they are listed likeliest-first for good reason. Following that order distinguishes a fast owner check on the dishwasher from a fault that needs trained service and correct Frigidaire parts.
- Power outage or surge — the supply was interrupted
- Tripped breaker — the circuit cut out
- Loose or shared supply — a poor connection drops voltage
- Low voltage — an overloaded circuit sags under load
Troubleshooting steps you can try
Start at the top of this list and work through your Frigidaire dishwasher in order rather than jumping ahead. If you reach a step involving live electricity, gas, a hot oven cavity, water, or a sealed part of the dishwasher, stop and let a qualified technician continue.
- Press START/CANCEL to clear PF and restart the cycle.
- Confirm the breaker is on and the plug is firm.
- Avoid sharing the circuit with high-draw appliances.
- If PF keeps returning without outages, have the house wiring checked.
Parts a technician may replace
After the fault is traced on a Frigidaire dishwasher, the parts most likely to be inspected, tested, or replaced are the house wiring, outlet, circuit breaker, and control board. Components for the dishwasher are matched from its model and serial number, and genuine OEM parts arrive through trusted parts suppliers rather than generic substitutes, protecting performance, safety, and the long working life of the appliance. Confirming the failed part first keeps the repair on your dishwasher focused and proportionate.
When to call a technician
Recurrent PF with no actual power loss needs an electrician or technician to check the supply circuit and connection. The Low severity rating means your dishwasher is not in danger, but where PF returns once the checks above are done, it is worth a technician confirming the cause on the dishwasher before parts are bought. Our service is independent and not affiliated with the manufacturer: the technicians who handle your dishwasher are experienced and skilled, they fit genuine OEM parts from trusted parts suppliers, and a 30-day labor warranty stands behind the work on your dishwasher. Booking is quickest with the model and serial number of your Frigidaire dishwasher in front of you, since the right part can then be matched before the visit and the PF condition sorted in as few trips as possible.
Related help and Frigidaire resources
If the PF condition keeps returning after these checks, book Frigidaire dishwasher repair, browse our dishwasher error-code guides and step-by-step repair guides, or schedule service in your area on our locations page. See also the related HO heat-delay status. Full manufacturer specifications for your Frigidaire dishwasher, plus the model lookup, are published at frigidaire.com.
