What E25 means on your Frigidaire dryer (frigidaire e25 error)
A frigidaire e25 error means a temperature-sensor (thermistor) fault on your Frigidaire dryer, the companion to E24. The control cannot trust the thermistor reading, so it flags E25 and may limit heat. The thermistor or its wiring is the usual cause.
Symptoms
What your Frigidaire dryer is doing should line up with the list below if this is genuinely the fault and not merely something that resembles it. The dryer may present one sign or many, sometimes across several cycles and sometimes right after a power cut, a heavy load, or a recent installation.
- Poor or uneven drying
- The cycle times out
- The code appears during the cycle
- Heat is too high or too low
Common causes
A single set of symptoms on your Frigidaire dryer can come from any of the causes below, listed with the common ones first. Eliminating them methodically separates the quick checks anyone can make on a dryer from the faults that need trained diagnosis and genuine Frigidaire parts.
- Failed thermistor — the sensor reads out of range
- Wiring or connector fault — the sensor circuit is degraded
- Restricted airflow — a clogged vent affects the reading
- Control-board fault — the input is misread
Troubleshooting steps you can try
Take the checks below on your Frigidaire dryer from first to last before arranging service, and note what changes as you go. Stop at any point on the dryer where you are unsure, or where live electricity, gas, a hot oven cavity, water, or a sealed component is within reach, and leave that to a professional.
- Clean the lint filter and clear the full vent run.
- Power-cycle the dryer and run a timed cycle.
- Check for kinks or lint blockage in the exhaust.
- If E25 returns, the thermistor needs testing.
Parts a technician may replace
This condition on a Frigidaire dryer can end at any of several components, and the ones usually inspected, tested, or replaced are the thermistor, sensor wiring, exhaust vent, and control board. The part your dryer takes is matched from its model and serial number, and genuine OEM components are fitted through trusted parts suppliers instead of generic substitutes, so performance, safety, and the appliance long working life are all protected. Testing before ordering means nothing is fitted to the dryer that did not need fitting.
When to call a technician
E25 generally needs a technician to measure and replace the thermistor. Medium severity means the dryer can wait, but not indefinitely: if E25 keeps returning once you have finished the checks, a technician should confirm the cause on the dryer before parts are bought. Our service is independent and not affiliated with the manufacturer: the technicians who handle your dryer are experienced and skilled, they fit genuine OEM parts from trusted parts suppliers, and a 30-day labor warranty stands behind the work on your dryer. Booking is quickest with the model and serial number of your Frigidaire dryer in front of you, since the right part can then be matched before the visit and the E25 condition sorted in as few trips as possible.
Related help and Frigidaire resources
If the E25 condition keeps returning after these checks, book Frigidaire dryer repair, browse our dryer error-code guides and step-by-step repair guides, or schedule service in your area on our locations page. See also the related E24 thermistor fault. To pull the manufacturer specifications for a Frigidaire dryer or run a model lookup, go to frigidaire.com.
