What i10 means on your Frigidaire dishwasher (frigidaire i10 error)
A frigidaire i10 error means the control did not sense enough incoming water within the allotted fill time on your Frigidaire dishwasher. The unit expects a set amount of water during fill, and when the level stays low it stops to protect the pump and your dishes. It usually points to a supply or inlet restriction rather than a control fault.
Symptoms
These are the indicators that pin the condition on your Frigidaire dishwasher instead of a lookalike fault that would need a different fix. The dishwasher might produce a lone sign or a handful at once, either building gradually or appearing abruptly after a power cut, a hard cycle, or recent handling.
- The dishwasher stops early in the cycle
- Dishes come out dry or still dirty
- There is little or no water in the tub
- A long cycle that never completes properly
Common causes
It takes only one of the faults below to make a Frigidaire dishwasher act like this, but they are listed likeliest-first for good reason. Following that order distinguishes a fast owner check on the dishwasher from a fault that needs trained service and correct Frigidaire parts.
- Water supply off or low pressure — the under-sink valve is closed or household pressure is weak
- Kinked or frozen inlet hose — the fill hose is restricted behind the unit
- Clogged inlet-valve screen — the small mesh screen at the valve is blocked
- Failed water inlet valve — the valve no longer opens fully (technician)
Troubleshooting steps you can try
Attempt the following on your Frigidaire dishwasher step by step before you call anyone out. Anything on the dishwasher that involves mains power, gas, a hot cavity, water, or a sealed component is where you should stop and bring in a qualified technician.
- Confirm the under-sink supply valve is fully open and the home has normal water pressure.
- Inspect the fill hose behind the dishwasher for kinks or crimps.
- Close the supply, then clean the small inlet-valve screen where the hose meets the valve.
- Press START/CANCEL to drain and clear, then restart; if i10 returns the inlet valve may need testing.
Parts a technician may replace
The diagnosis decides the parts, but on a Frigidaire dishwasher this condition commonly involves the water supply valve, inlet hose, inlet-valve screen, and water inlet valve. Whatever the dishwasher needs is matched from its model and serial number, and genuine OEM components come from trusted parts suppliers rather than generic substitutes, protecting the performance, safety, and long working life of the appliance. Confirming exactly what has failed on the dishwasher before ordering keeps the repair tight and the cost honest.
When to call a technician
i10 that returns with the supply open and the screen clean needs a technician to test the water inlet valve and fill circuit. Being Medium severity, this will not damage your dishwasher overnight, but where i10 survives the checks above, a technician should confirm the cause on the dishwasher before parts are fitted. We operate as an independent repair service, unaffiliated with the manufacturer, sending experienced and skilled technicians to your dishwasher with genuine OEM parts from trusted parts suppliers, and our workmanship on the dishwasher is backed by a 30-day labor warranty. When booking, have your Frigidaire dishwasher model and serial number to hand so the correct part for your build is matched before the visit and the i10 condition finished in as few trips as possible.
Related help and Frigidaire resources
If the i10 condition keeps returning after these checks, book Frigidaire dishwasher repair, browse our dishwasher error-code guides and step-by-step repair guides, or schedule service in your area on our locations page. See also the related i20 drain code. You can look up the model of your Frigidaire dishwasher and read its full specifications at frigidaire.com.
