What CE means on your Frigidaire dishwasher (frigidaire ce error)
A frigidaire ce error means the control configuration or calibration does not match the appliance on your Frigidaire dishwasher. It typically appears after a control board has been replaced without being configured to the model. The dishwasher holds operation until the mismatch is resolved.
Symptoms
Checking these signs against your Frigidaire dishwasher keeps you from chasing the wrong fault, because look-alike problems call for quite different repairs. A dishwasher can show a single symptom or several combined, creeping in gradually or appearing suddenly after a surge, a spill, or fresh install work.
- The code appears after a board replacement or service
- The dishwasher will not start a cycle
- Settings behave incorrectly
- An error is reported at power-up
Common causes
More than one fault can drive this behaviour on a Frigidaire dishwasher, so it pays to weigh the likeliest causes before the rare ones. Ruling them out in order shows whether your dishwasher has an owner-fixable issue or one that calls for a technician and the right components.
- Unconfigured replacement board — the new board was not set to the model
- Mismatched board — an incompatible board was fitted
- Corrupted configuration — stored settings were lost
- User-interface mismatch — the panel and main board do not agree
Troubleshooting steps you can try
Take the checks below on your Frigidaire dishwasher from first to last before arranging service, and note what changes as you go. Stop at any point on the dishwasher where you are unsure, or where live electricity, gas, a hot oven cavity, water, or a sealed component is within reach, and leave that to a professional.
- If the unit was just serviced, the configuration step was likely missed.
- Power-cycle to confirm CE is persistent rather than a one-time glitch.
- Do not attempt to reconfigure the board yourself.
- Book service to set the correct configuration.
Parts a technician may replace
A technician diagnosing your Frigidaire dishwasher may check, test, or renew the main control board and user-interface board, depending on where the fault lands. The correct component for the dishwasher is identified from the model and serial number, and genuine OEM parts are sourced through trusted suppliers rather than generic substitutes, so the safety and working life of the dishwasher are not compromised. Pinning down the failed part before ordering avoids replacing more of the dishwasher than the fault calls for.
When to call a technician
CE needs a technician to configure or replace the control board to match your exact model. Rated High severity, this fault means the dishwasher should not be run again while you wait; arrange service promptly, and cut power or water to the dishwasher at the source if anything looks, smells, or sounds unsafe. As an independent repair service unaffiliated with the manufacturer, we put experienced, skilled technicians in front of your dishwasher and fit only genuine OEM parts from trusted parts suppliers, with a 30-day labor warranty on the workmanship carried out on the dishwasher. Booking with your Frigidaire dishwasher model and serial number to hand lets the right part be matched before the visit, so the CE condition is resolved in as few trips as possible.
Related help and Frigidaire resources
If the CE condition keeps returning after these checks, book Frigidaire dishwasher repair, browse our dishwasher error-code guides and step-by-step repair guides, or schedule service in your area on our locations page. See also the related iC0 communication fault. The official specifications for a Frigidaire dishwasher, along with the model lookup, live at frigidaire.com.
