What E57 means on your Frigidaire washer (frigidaire e57 error)
A frigidaire e57 error means an over-current condition on the inverter on your Frigidaire front-load washer. The inverter, or motor control board, drives the motor, and excessive current there triggers a protective shutdown. It is an electronics-level fault.
Symptoms
Checking these signs against your Frigidaire washer keeps you from chasing the wrong fault, because look-alike problems call for quite different repairs. A washer can show a single symptom or several combined, creeping in gradually or appearing suddenly after a surge, a spill, or fresh install work.
- The cycle stops during spin or agitation
- The code recurs under load
- The motor does not run smoothly
- The spin is skipped
Common causes
Any one of the causes below can be behind what your Frigidaire washer is doing, which is why they are ranked by likelihood. Checking them in that order helps you judge whether your washer needs a homeowner check or a skilled technician with genuine Frigidaire components.
- Inverter board fault — the motor control board is failing
- Shorted or failing motor — the motor pulls too much current
- Wiring fault — the inverter-to-motor link is degraded
- Power-supply disturbance — incoming power is unstable
Troubleshooting steps you can try
Go through the following on your Frigidaire washer in the order shown, and stop as soon as the fault clears. Any step on the washer that puts you near live wiring, gas, a hot oven cavity, water, or a sealed system is one to leave to a qualified technician.
- Power-cycle the washer at the breaker for several minutes.
- Reduce load size to lower motor demand.
- Confirm the outlet and breaker are sound.
- If E57 returns, the inverter and motor need testing.
Parts a technician may replace
Once the fault is confirmed on your Frigidaire washer, the components most often inspected, tested, or replaced are the inverter board, motor control board, drive motor, and wiring. Parts for the washer are matched from its model and serial number, and genuine OEM components come through trusted parts suppliers instead of generic substitutes, protecting performance, safety, and the long working life of the appliance. Identifying the failed part first means nothing is swapped on the washer that did not need swapping.
When to call a technician
E57 generally needs a technician to test the inverter board and drive motor. This is a High severity condition, so the washer should be taken out of use and service arranged promptly instead of running it again — and if anything about the washer looks, smells, or sounds wrong, isolate its power or water supply at the source first. We are independent and hold no affiliation with the manufacturer; the technicians who repair your washer are experienced and skilled, the components fitted to the washer are genuine OEM parts from trusted parts suppliers, and a 30-day labor warranty backs the workmanship. Quote the model and serial number of your Frigidaire washer when you book so the right part is matched ahead of the visit and the E57 condition put right in as few trips as possible.
Related help and Frigidaire resources
If the E57 condition keeps returning after these checks, book Frigidaire washer repair, browse our washer error-code guides and step-by-step repair guides, or schedule service in your area on our locations page. See also the related E58 motor-phase current. You can look up the model of your Frigidaire washer and read its full specifications at frigidaire.com.
