What ER means on your Frigidaire dishwasher (frigidaire er error)
A frigidaire er error means the control senses a key held or stuck on the touchpad of your Frigidaire dishwasher. When a membrane key reads continuously pressed the control cannot accept new input and flags ER. A power-cycle often clears a one-time glitch.
Symptoms
What your Frigidaire dishwasher is doing should line up with the list below if this is genuinely the fault and not merely something that resembles it. The dishwasher may present one sign or many, sometimes across several cycles and sometimes right after a power cut, a heavy load, or a recent installation.
- An unresponsive or erratic touchpad
- The unit beeps or refuses input
- A button that feels sticky
- The cycle will not start
Common causes
There is rarely one obvious culprit on a Frigidaire dishwasher, so the possibilities below are sorted from probable to unlikely. Testing them in that order tells you whether your dishwasher needs a small adjustment or a repair with genuine OEM parts from trusted suppliers.
- Failed membrane switch — the touchpad reads a key held
- Trapped moisture or debris — something is bridging a key
- Ribbon or connector fault — the keypad link is degraded
- Control-board fault — the board misreads the keypad (technician)
Troubleshooting steps you can try
These are the checks worth making on your Frigidaire dishwasher before you spend money on a service call. Anywhere the job on the dishwasher touches mains voltage, gas, a hot cavity, water, or a sealed component, stop and hand it over to a qualified technician.
- Power-cycle at the breaker for a minute and retry.
- Wipe the control panel and gently work each key to free a stuck one.
- Note which pad, if any, triggers the code.
- If ER returns, the touchpad or control needs service.
Parts a technician may replace
This condition on a Frigidaire dishwasher can end at any of several components, and the ones usually inspected, tested, or replaced are the membrane switch, touchpad, ribbon connector, and control board. The part your dishwasher takes is matched from its model and serial number, and genuine OEM components are fitted through trusted parts suppliers instead of generic substitutes, so performance, safety, and the appliance long working life are all protected. Testing before ordering means nothing is fitted to the dishwasher that did not need fitting.
When to call a technician
ER that returns after a reset needs a technician to test the membrane touchpad and control board. With a Medium severity rating there is no need to rush, but if your dishwasher keeps returning ER after these checks, let a technician confirm the cause on the dishwasher before a part is ordered. As an independent repair service unaffiliated with the manufacturer, we put experienced, skilled technicians in front of your dishwasher and fit only genuine OEM parts from trusted parts suppliers, with a 30-day labor warranty on the workmanship carried out on the dishwasher. Booking with your Frigidaire dishwasher model and serial number to hand lets the right part be matched before the visit, so the ER condition is resolved in as few trips as possible.
Related help and Frigidaire resources
If the ER condition keeps returning after these checks, book Frigidaire dishwasher repair, browse our dishwasher error-code guides and step-by-step repair guides, or schedule service in your area on our locations page. See also the related iC0 communication fault. Full specifications and model lookup for your Frigidaire dishwasher can be found on frigidaire.com.
