What hs means on your Frigidaire dishwasher (frigidaire hs error)
A frigidaire hs error means the wash-motor Hall (speed) sensor is faulted on your Frigidaire dishwasher. That sensor reports motor speed back to the control, and without a valid signal the control cannot regulate the wash motor and flags hs. It is a motor-level fault.
Symptoms
What your Frigidaire dishwasher is doing should line up with the list below if this is genuinely the fault and not merely something that resembles it. The dishwasher may present one sign or many, sometimes across several cycles and sometimes right after a power cut, a heavy load, or a recent installation.
- Weak or no spray pressure
- The cycle aborts partway
- The motor runs erratically
- Unusual motor noise during wash
Common causes
Several separate faults can leave your Frigidaire dishwasher behaving this way, so the causes below run from the most likely to the least. Working through them in that order on the dishwasher tells a quick owner-level check apart from a problem that needs an experienced technician and the correct Frigidaire parts.
- Failed Hall sensor — the motor speed sensor no longer reports
- Wiring or connector fault — the sensor circuit is open
- Debris stalling the motor — the impeller is jammed
- Control-board fault — the speed signal is misread (technician)
Troubleshooting steps you can try
Work down this list on your Frigidaire dishwasher one step at a time before booking a visit. If a step on the dishwasher brings you near live wiring, gas, a hot oven cavity, standing water, or a sealed system, stop there and hand it to a qualified technician.
- Power-cycle the dishwasher at the breaker for five minutes.
- Confirm the spray arms turn freely and nothing jams the impeller.
- Note any change in motor sound during the wash.
- If hs returns, the wash motor and Hall sensor need testing.
Parts a technician may replace
A technician diagnosing your Frigidaire dishwasher may check, test, or renew the wash-motor hall sensor, motor wiring, and control board, depending on where the fault lands. The correct component for the dishwasher is identified from the model and serial number, and genuine OEM parts are sourced through trusted suppliers rather than generic substitutes, so the safety and working life of the dishwasher are not compromised. Pinning down the failed part before ordering avoids replacing more of the dishwasher than the fault calls for.
When to call a technician
hs generally needs a technician to test the wash-motor Hall sensor and control board. A Medium severity rating gives you time with the dishwasher, not a free pass: should hs keep returning after these checks, a technician should confirm the cause on the dishwasher before any part is replaced. This is an independent repair service, not affiliated with the manufacturer — experienced, skilled technicians work on your dishwasher, genuine OEM parts come from trusted parts suppliers, and the workmanship on the dishwasher carries a 30-day labor warranty. Have your Frigidaire dishwasher model and serial number ready when you book, so the right part for your exact build is matched before the visit and the hs condition dealt with in as few trips as possible.
Related help and Frigidaire resources
If the hs condition keeps returning after these checks, book Frigidaire dishwasher repair, browse our dishwasher error-code guides and step-by-step repair guides, or schedule service in your area on our locations page. See also the related i50 motor fault. The official specifications for a Frigidaire dishwasher, along with the model lookup, live at frigidaire.com.
